Need help?Do you have a question about the Icom IC-F50 and is the answer not in the manual?
General| Type | Handheld |
|---|---|
| Power Output | 5W |
| Mode | FM |
| Ingress Protection | IP54 |
| Model | IC-F50 |
| Frequency Range | 136-174 MHz |
| Channel Capacity | 128 channels |
Details how to transmit emergency calls, including silent and repeat options.
Steps to rotate the volume knob to turn the transceiver ON and handle passcode entry.
Explains methods for selecting operating channels, including non-bank, bank-type, and automatic scan.
Details the steps for making selective or non-selective calls using tone signalling.
Instructions on how to receive calls and transmit voice communications, including microphone placement.
Details the process of receiving and responding to an individual BIIS call.
Details the process of receiving and responding to a group BIIS call.
Guides on transmitting calls using stored call codes from memory.
Details how to initiate calls by selecting records from the queue channel.
Explains how to enter and transmit specific TX codes directly.
Describes how to receive status messages, including display and manual scrolling.
Details the reception of status messages and how to view them.
Explains how to receive Short Data Messages (SDM) and scroll through them.
Instructions on selecting and transmitting status messages to stations or groups.
Details how to select and transmit Short Data Messages (SDM) to stations or groups.
Describes automatic emergency signal transmission upon pressing emergency keys.
Explains how the stun function is activated by a killer ID and requires a passcode.
Explains the capabilities of the MDC 1200 system and the concept of aliasing for IDs.
Guides on making selective calls using MDC 1200 system aliases.
Details how to initiate selective calls to specific stations or groups using MDC 1200.
Explains how to send a call alert to notify another user of your desire to talk.
Describes how to perform a radio check to determine if another transceiver is on and in range.
Guides on sending pre-programmed status messages to the dispatcher.
Explains how to send pre-programmed messages to the dispatcher.
Details how the MDC 1200 Emergency feature sends repeated commands to the dispatcher.
Explains how dispatchers can stun or revive transceivers using MDC 1200 signals.
Describes how to receive selective calls and call alerts in the MDC 1200 system.
Details the process of receiving and responding to MDC 1200 selective calls.
Explains how to receive and acknowledge MDC 1200 call alerts.
Details how to receive emergency calls and stop the indication/beeps.
Lists critical cautions for handling battery packs, charging, and preventing damage or explosion.
Details rapid charging of Li-Ion battery packs using BC-119N and AD-100 adapter.
To Next Page
