12
2
IDAS OPERATION
Receiving a call (Continued) ■
Receiving a Stun, Kill or Revive D
If an individual call with a Stun or Kill command is received
(RAN code matching may not be necessary depending on
the presetting), the transceiver will display “SORRY”
*
1
and
you cannot receive
*
2
or transmit.
*
1
Except for the IC-F3210D/IC-F4210D series transceivers.
*
2
Depending on the received Stun command setting.
When a Stun command is received: ➥
• The transceiver cannot be operated until the individual
call with a Revive command is received or the password
is input. RAN code matching may not be necessary, de-
pending on the presetting.
When a Kill command is received: ➥
• The transceiver cannot be operated until data cloning is
performed. Ask your dealer for details.
NOTE: Depending on the presetting, the transceiver can
ignore the Stun, Revive and Kill commands that are from a
non-specified station.
Receiving a Remote Monitor, Radio Check D
or Status Polling Call
If an individual call with Remote monitor, Radio check or Sta-
tus polling command is received, the transceiver will automat-
ically transmit. RAN code matching may not be necessary,
depending on the presetting.
When a Remote monitor command is received: ➥
• The microphone audio is automatically transmitted for the
set time period.
When a Radio check command is received: ➥
• The transceiver automatically transmits an acknowledge-
ment call.
➥ When a Status polling command is received:
• The transceiver automatically transmits a status call.
To Next Page
Loading...
Need help?
General
