Icom IC-F5220D - Position Data Transmission; Status Message Transmission; Encryption Function

27
2
IDAS OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Position data transmission ■
When a GPS receiver is connected to the transceiver, the lon-
gitude and latitude position data can be automatically trans-
mitted when:
• A GPS request status message is received
• After sending a voice message
- Set the ‘Send with Login’ and ‘Send with Logoff’ items to
‘Enable.’
• After sending a status message
- Set the ‘Send with Status Call’ item to ‘Enable.’
• After sending a message
- Set the ‘Send with SDM Call’ item to ‘Enable.’
• After sending a Call Alert
- Set the ‘Send with Call Alert’ item to ‘Enable.’
• After sending an Emergency call
- Set the ‘Send with Emergency’ item to ‘Enable.’
Ask your dealer or system operator for a GPS receiver con-
nection details.
Status message transmission ■
The status message can be automatically transmitted.
The status message is transmitted when:
• The transceiver is turned ON or OFF
- Set the status message to be transmitted in ‘Power ON Status’ or
‘Power OFF Status’ item, respectively.
- Set the target station ID in ‘Power Status ID,’ ‘Power Status ID for
Single-site Trunk’ or ‘Power Status ID for Multi-site Trunk.’
• After sending a voice message
- Set the ‘Send with Voice Call’ item to ‘Enable.’
- Set the status message to be transmitted in ‘Send Status Num-
ber’ item.
Encryption function ■
The encryption function enables voice scrambling, which pro-
vides private digital communication between stations.
Push [Encryption] to turn the Encryption function ON or ➥
OFF.
• “ ” (For the IC-F3230D/F4230D series transceivers) or “ ”
(For the IC-F5220D/F6220D series transceivers) appears when
the Encryption function is ON.