Icom IC-F620 - Page 6

SECTION 3 DISASSEMBLY INSTRUCTIONS
3 - 1
• Opening case
➀ Unscrew 4 screws A, and remove the bottom cover.
➁ Disconnect the flat cable B from J2.
➂ Unscrew 2 screws c, and remove the front unit.
A
B
C
J2
➃ Unsolder 1 point D from the plate, and remove the plate.
➄ Unsolder 3 points E from the antenna connector.
➅ Remove the clip F.
➆ Disconnect the cable G from J5.
➇ Unscrew 11 screws H.
H
G
F
D E
J5
➈ Lift up the front portion of the main unit and remove it.
• Instllation location
UT-105 SmarTrank2 Logic Board
UT-108 DTMF decoder unit
UT-109
Voice scrambler unit
UT-110
UT-111 Trunking unit
UT-105
UT-108
UT-109
UT-110
UT-111
J1