Icom IC-F621 Service Manual

SECTION 3 DISASSEMBLY INSTRUCTIONS
3 - 1
• Removing the front unit
➀
Unscrew 4 screws A, and remove the bottom cover.
➁ Disconnect the flat cable B from J2.
➂ Unscrew 2 screws c, and remove the front unit.
A
A
B
C
C
J2
• Removing the main unit
➀ Unsolder 1 point D from the plate, and remove the plate.
➁ Unsolder 3 points E from the antenna connector.
➂ Remove the clip F.
➃ Disconnect the cable G from J5.
➄ Unscrew 11 screws H.
H
H
H
G
F
D E
J5
➅ Lift up the front part of the main unit and remove it.
• Optional unit and cable instllation location
UT-105 SmarTrankII Logic Board
UT-108 DTMF decoder unit
UT-109 Voice scrambler unit (non-rolling type)
UT-110 Voice scrambler unit (rolling type)
UT-111 Trunking unit
OPC-617 ACC cable
OPC-822 Interface cable
OPC-617
OPC-822
UT-105, UT-108
UT-109, UT-110
UT-111
J1
J6
J9
Continue to right above.

Icom IC-F621 Specifications

General

Brand	Icom
Model	IC-F621
Category	Transceiver
Language	English