Icom IC-F9511T User Manual

■
Individual call

Receiving
APCO P25 Mode Operation
■
Individual call
Transmitting
Individual call allows you to make a call to a specific
station, and it provides private communication.
[Individual] key assignment is necessary to transmit
the Individual call.
1
Push
[Individual]
to enter the Individual ID

Receiving
1 When an Individual call is received;
• The Busy indicator lights green.
• The ringer sounds. (Depending on the pre-
setting.)
• The calling station ID (or name) is displayed for
2 sec. (Depending on the pre-set value.)
• Depending on the pre-set value, the transceiver
d t th l h d i ti
1
Push
[Individual]
to enter the Individual ID
selection mode.
• A pre-programmed ID name is displayed.
• When the ID name is not programmed, the ID
code is displayed.
• Push again to cancel and return to normal
operation.
d
oes
no
t
open
th
e
sque
l
c
h
,
an
d
commun
i
ca
ti
on
is not established, if the Individual ID or NAC
(Network Access Code) is not matched.
2Select the desired Individual ID (or name) using
[CH Up]/[CH Down] or [CH Up/Down].
• The Individual ID can be edited with the
10
-
keypad*. (Depending on the pre
-
set value.)
T
he calling station name ( or ID )
2 Push and hold [PTT] and speak into the
microphone.
3 Release [PTT] to receive a response.
▒ For P25 Trunking mode operation:
▒
When the Full Off Air Call
SetUp
(FOACSU) function
*10-key models only.
▒ To edit the Individual ID using the 10-keypad:
 Input the Individual ID directly with the 10-keypad.
 • Push [] to clear a code.




▒
When the Full Off Air Call
SetUp
(FOACSU) function
▒ is turned ON, beeps sound after receiving a call. In
▒ that case, push [PTT] to accept the call. Then,
▒ operate as described in steps ② and ③ above. If
▒ you ignore the call by not pushing [PTT] for a
▒ specified time period*, communication is not
▒ established. Or, pushing [Home] after receiving the
▒ call will also ignore it.

3 Push and hold [PTT] to transmit the Individual call
to the target station, then speak into the
microphone.
• The Transmit indicator lights red.
• Depending on the pre-set value, the target station
does not open the squelch, and communication
■ Talkgroup call
Transmitting
A Talkgroup call allows you to make a call to a
specific group only. [Talkgroup] key assignment is
necessary to transmit the Talkgroup call.
✔ For
Trunkin
g
mode o
p
eration:
is not established, if the Individual ID or NAC
(Network Access Code) is not matched.
4Release [PTT] to receive.
g
p
The [Talkgroup] key is not usable while in the
Trunking mode. To make a Talkgroup call, the group
affiliation should be performed with the desired
Talkgroup ID to call.
1 Push [Talkgroup] to enter the Talkgroup ID
(or name) selection mode.
• A pre-programmed ID name is displayed.
45
• When the ID name is not programmed, the ID
code is displayed.
• Push again to cancel and return to normal
operation.

Icom IC-F9511T Specifications

General

Brand	Icom
Model	IC-F9511T
Category	Transceiver
Language	English