Icom IC-M400BB - ATIS Code Programming

3
2
PREPARATION
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
New2001
The 10 digit ATIS (Automatic Transmitter Identification Sys-
tem) code can be programmed at power ON.
The code is programmed by using the HM-195.
This initial code setting can be performed only once.
After being set, it can be changed by only your dealer
or distributor. If your ATIS code has already been pro-
grammed, this programming is not necessary.
After programming the MMSI code, “Push [ENT] to Regis- q
ter Your ATIS” is displayed.
Push [ENT] to start the ATIS code programming. w
 •Push[CLEAR]twicetocanceltheprogramming,andgotothe
normal operating mode. In this case, the ATIS function is dis-
abled. To program the ATIS code, turn OFF the power, then turn
it ON again.
Enter your ATIS code in the following manner: e
 •SelectadesirednumberusingDial,or[∫]/[√]/[Ω]/[≈].
 •Push[ENT]orDialtosetit.
 •Tomovethecursor,selecteitherarrow,“←” or “→,” then push
[ENT] or Dial.
Repeat step r e to enter all 10 digits.
After entering the 10 digit code, “FINISH” is automatically t
selected, and then push [ENT] or Dial to set it.
The “ATIS CONFIRMATION” screen is displayed. y
Enter your ATIS code again for confirmation. u
 •Enterinthesamemannerasstepse through t.
When your ATIS code programming is successfully com- i
pleted, the screen shown below is briefly displayed.
 •Afterthat,thenormaloperatingscreenisdisplayed.
The programmed ATIS code can be checked in the MENU
screen.
ATIS code programming ■ (For Dutch version transceivers)