Icom IC-M700PRO Instruction Manual

6
3
SELECTING A CHANNEL
D Scan function
The scan function allows you to automatically search
channels within a group for signals. There are 2 scan
types (selectable in set mode) as follows:
Scan operation
➀ Rotate the [GROUP] selector to select the group
you wish to scan.
➁ Push [SQL] to close the squelch if necessary.
•“SQL” appears.
➂ Push [SCAN] to start scanning.
•“SCAN” appears.
➃ Push [SCAN] again to stop scanning.
•“SCAN” disappears.
Channel scan
ch 1
ch 2 ch 3
ch 4
ch 5ch 50
scan is
cancelled
when
transmitting
Channel resume scan
ch 1
ch 2 ch 3
ch 4
ch 5ch 50
scan pauses
for 10 sec. after
the squelch
opens,
then resumes
■ Selecting a frequency
The transceiver has 0.5 to 30.0 MHz general coverage
receive capability with 100 Hz resolution. Use VFO
mode to select frequencies around the prepro-
grammed channels in memory mode.
☞ NOTE: Frequencies selected in VFO mode are for
temporary use and are not stored in memory.
➀ While in memory mode, rotate the [GROUP] and
[CHANNEL] selectors to select the channel nearest
the frequency you want.
➁ Push [CH/FREQ] to select VFO mode.
•“FREQ” appears.
➂ Rotate the [CHANNEL] selector to select the de-
sired frequency.
• Frequency changes in 100 Hz steps.
Rotate
[CHANNEL]
to select a
frequency in
0.1 kHz steps
1.6 MHz selected
1.6001 MHz selected
SIMP
SQL
SIMP
SQL

Icom IC-M700PRO Specifications

General

Brand	Icom
Model	IC-M700PRO
Category	Telephone
Language	English