What to do if Icom IC-SAT100 cannot transmit?
If your Icom Transceiver doesn't transmit, it could be due to a discharged battery. Try recharging the battery pack. Alternatively, there might be an obstruction between the transceiver and the satellite. In this case, attempt to transmit from a location free of any obstacles.
How to unlock the keypad on Icom Transceiver?
If you cannot use the keypad on your Icom Transceiver, the Key Lock function may be activated. To deactivate it, push [P2] until “Lock OFF” is displayed.
Why my Icom IC-SAT100 Transceiver does not turn on?
If your Icom Transceiver does not turn on, the battery may be exhausted. Try recharging it. Also, ensure that the battery pack is correctly attached. If not, reattach it properly.
How to enable beep sounds on Icom Transceiver?
General| Operating Temperature Range | -20°C to +60°C |
|---|---|
| Audio Output Power | 500 mW |
| Ingress Protection | IP67 |
| GPS | Yes |
| Bluetooth | Yes |
| Type | Satellite Transceiver |
| Channel Spacing | 25 kHz |
| Mode | Digital |
| Waterproof | Yes |
To Next Page
