Icom IC-T22E - Memory Channel Management

@ Selecting a memory channel
® Push [MR] to select memory
mode. @
@ Push 2 digit keys to select
the desired memory chan-
nel.
*The first nine memory chan-
nels are preceded by a “0.”
* To select scan edges 1A to 3B,
use [*] for “A” and [#] for“B”
Bret rhode po
channels can be selected.
© Other methods
‘» VIA THE DIAL: Rotate [DIAL] to change the memory chan-
nel.
‘» VIA [FUNC] + THE DIAL: Rotate [DIAL] while pushing
[FUNC] to select the scan edge memories, 1A to 3B.
VIA THE [A]J[V] KEYS: Push [AJ/[V] to increment/decre-
ment the memory channel.
BASIC OPERATION 3
@ Setting tuning dial increments
© Tuning step selection
This transceiver has 8 tuning steps as follows:
*5 kHz © 10 kHz *12.5kHz °15kHz
*20kHz *25kHz 8 *30kHz © 50 kHz
@ Push [FUNC] + [@TS] to enter the tuning step setting con-
dition.
* Previously selected tuning step appears.
@ Rotate [DIAL] to select the desired tuning step.
@ Push [(vro)CLR] to set the selected tuning step.
For convenience, select a tuning step that matches the fre-
quency intervals of repeaters in your area.
[DISPLAY EXAMPLE]