5
New2002
‘‘
STATIC OPERATIONAL CHECKS
Start the engine of the vehicle and repeat ALL the tests de-
scribed in ‘TESTING’.
Check that there is no disturbance of the engine control or
engine speed.
With the help of an assistant, switch on the vehicle lights, in-
dicators, etc. while transmitting. Check that no unintended
flashing or indication occurs.
Stop the engine. If the above checks have been completed
without problem you can proceed to the mobile operational
checks.
‘ MOBILE OPERATIONAL CHECKS
DO NOT PERFORM THESE CHECKS IN CITY TRAFFIC!
Find a quiet road, start the vehicle and while moving slowly
operate the transmitter. Check that brakes, etc. all operate as
normal. Repeat using bands, modes, etc. as applicable to
your transceiver.
If all is OK, then increase to normal driving speed and repeat
the tests. If there is any unexpected reaction from the vehicle
(accelerator, transmission, steering or other in-car electronic
device) then stop immediately and seek assistance from a
qualified installation engineer before operating the trans-
ceiver.
If all is OK, perform a final braking test at normal speed while
transmitting.
MOBILE RADIO INSTALLATION.qxd 02.7.25 09:54 AM Page 5 (1,1)
To Next Page
Loading...
