ICON MOTOSPORTS ALLIANCE MANUAL
ICON MOTOSPORTS ALLIANCE HELMET
No helmet can protect the user against all foreseeable impacts. For your safety, please choose a helmet in the size which fits your head
(refer to the helmet size chart on page 4). For maximum head protection, should fi t properly, and the retention system must be
securely fastened under the chin. To ensure a proper fit, please follow the steps below:
1. Position the helmet on your head so that it sits low on your forehead. If you can’t see the edge of the brim at the extreme upper range
of your vision, the helmet is probably out of place. Adjust the retention system so that when in use, it will hold the helmet fi rmly in place.
2. With the chinstrap still fastened as tightly as possible, take hold of the helmet with both hands. Without moving your head, try to
move the helmet up and down, and from side to side. You should feel the skin of your head and face being pulled as you try to
move the helmet. If you can move the helmet around easily, it is too big. To determine a correct fi t try a smaller size.
3. Now, with the chinstrap secured, put your hands flat on the back of the helmet and try to pull the helmet off by rotating it forward.
Then, put your hands on the front of the helmet, and try to push the helmet off by rotating it toward the rear. If the helmet starts to
come off in either direction, the helmet is either too large, or the chinstrap is not fastened tightly enough.
In order for your helmet to function properly the chinstrap must always be securely fastened while in use. With the chin strap fastened, it
should not be possible to remove the helmet from your head by pulling up at the center rear. Check periodically to see that the vibration
has not caused the chin strap to loosen. Just give a little tug to make sure it is still tight.
To securely fasten the D-ring retention system, thread the end of the chin strap through the D-rings only as shown in the diagram below.
Fasten the female snap of the chin strap to the male snap to secure the loose end of the chin strap after the chin strap is securely
fastened. The only function of the snap fastener on the end of the chin strap is to keep it from flapping in the air stream. It is not part of
the retention system and should not be used independently without passing through the D-rings as illustrated below.
Please make sure that the chin strap is fastened as instructed above. Failure to do so may result in fatal injury.
To Next Page
Loading...
