ICON Alliance User Manual

ICON MOTOSPORTS ALLIANCE MANUAL
ICON MOTOSPORTS ALLIANCE HELMET
ICON IS A REGISTERED TRADEMARK. ALL RIGHTS RESERVED. COPYRIGHT© 2010 LEMANS CORPORATION.
REPLACEMENT PARTS AND SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE. PRINTED IN KOREATHE USA. REV. 01.
J-Tech Corp. Made in China REV000ECE/DOT
REPLACEMENT RECOMMENDATION
The fi ve year replacement recommendation is based on a consensus of all helmet
manufacturers, which certifi es all Icon helmets. Glues, resins and other materials
used in helmet production can effect liner materials over time. Hair oils, body
fl uids and cosmetics, as well as normal “wear and tear” also contribute to helmet
degradation. Additionally, petroleum based products present in cleaners, paints,
fuels, and other commonly encountered materials may break down materials used in
many helmets, possibly compromising performance. Experience indicates that helmet
standards are revised every fi ve years. This, coupled with advances in materials,
designs, and production methods suggest that it is in the riders best interest to
replace his/her helmet at a minimum of every fi ve years.
2
3
RIGHT CHEEK PAD LEFT CHEEK PAD
COMFORT LINER
CHIN CURTAIN
XXS
35
mm
XS
30
mm
S
30
mm
M
25
mm
L
30
mm
XL
25
mm
XXL
20
mm
3XL
20
mm
HELMET SHELL SIZE
15
mm
12
mm
15
mm
12
mm
12
mm
9
mm
7
mm
7
mm
1
2 31
4
EE5
6
3
2
2
1
1
2
1
ALLIANCE HELMET

ICON Alliance Specifications

General

Type	Full Face
Safety Standard	DOT FMVSS 218
Ventilation	Adjustable front vent and rear exhaust vents
Interior	Moisture-wicking
Liner	Removable
Chin Strap	Double D-Ring

Summary

Replacement Recommendation

Alliance Introduction

Construction

Helmet Sizing Chart

Guide to selecting the correct helmet size based on head measurements for optimal fit.

Proper Fitting

Chin Strap

Instructions on how to correctly fasten and secure the chin strap for proper helmet retention.

Alliance Shield

Shield Change Removal

Step-by-step instructions for removing and replacing the helmet's shield and side plates.

Interior

Comfort Liner Removal

Guide on how to remove the interior comfort liner for cleaning or replacement purposes.

Alliance Venting

Supervent System

Explanation of the helmet's ventilation system, including intake and exhaust port operation.

Care and Cleaning

Interior Cleaning

Instructions for cleaning the helmet's interior lining using mild solutions.

Exterior Cleaning (Gloss Helmets)

Methods for cleaning the exterior of gloss finish helmets, including bug removal.

Exterior Cleaning (Rubatone Helmets)

Recommended cleaning procedures for Rubatone finish helmets to preserve the matte surface.

Exterior Polishing

Guidance on polishing gloss helmet finishes with automotive wax.

Storage

Recommendations for proper helmet storage to protect it from damage and sunlight.

Shield Cleaning

Instructions for cleaning the helmet shield without damaging coatings.

Advisory

Advice on handling the helmet carefully and the implications of impacts.