ICON EDGE - Page 26

ICON EDGE USER MANUAL
25
9.6.5. Last Run Time
With this function, you can display last the running time of the lamp. The display shows “XXXXh”,
“XXXX” stands for the number of hours.
1． Tap <MODE/ESC>button，access the main menu，Tap the <Up/Down>button until“Info”is
displayed. Press ENTER.
2． Press <Up/Down>, until the display shows “Last Run Time”.
3． Press< ENTER>, the display will show “Last Run Time”.
4． The display will show “XXXXh” (Hours).
5． Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
9.6.6. Service Setting
Password: The Password for this function is “50”.
RDM UID: With this function you can call up various submenus via RDM.
Clear Err.Info: Clears the Error list (9.6.8)
This device is RDM ready. RDM stands for "remote device management" and makes remote control
of devices connected to the DMX-bus. ANSI E1.20-2006 by ESTA specifies the RDM standard as an
extension of the DMX512 protocol.
Manual settings like adjusting the DMX starting address are no longer needed. This is especially
useful when the device is installed in a remote area.
RDM ready and conventional DMX devices can be operated in one DMX line. The RDM protocol
sends own packages in the DMX512 data feed and does not influence conventional devices.
If DMX splitters are used and RDM control is to be used, these splitters must support RDM.
The number and type of RDM parameters depend on the RDM controller being used.
9.6.7. Fan Speed
With this function, you can set the speed of the running fans. The selection have Lamp Fan,
HeadFan1, HeadFan2 and Color Fan.
9.6.8. Error Info
1. Tap <MODE/ESC>button ， access the main menu ， Tap the <Up/Down>button until“Info”is
displayed. Press ENTER.
2. Press <Up/Down>, until the display shows “Error Info”.
3. Press <ENTER>, Display shows Error Records 1-10. Use <Up/Down>, to scroll through to 10.
4. Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
9.7. Test
9.7.1. Self Test
With this function you can test each channel on its (correct) function.
1． Tap <MODE/ESC>button，access the main menu，Tap the <Up/Down>button until“Test”is
displayed. Press ENTER.
2． Press <Up/Down>, until the display shows “Self Test”.
3． Press< ENTER>.
4． The display show“All”, Press <Up/Down>, the display will show“Internal Functions”, “Movement”,
“Individual Function”.
5． Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.