ICON EDGE - Page 25

ICON EDGE USER MANUAL
24
3． Press ENTER to confirm or press <MODE/ESC> to return to the main menu.
9.5.2. DMX Info
1． Tap <MODE/ESC>button ， access the main menu ， Press the <Up/Down>button
until“Communication”is displayed. Press <ENTER>. Tap the <Up/Down>button until“DMX Info”is
displayed. Press ENTER.
2． The display show “DMX Update Rate”.
3． Press ENTER to confirm or press <MODE/ESC> to return to the main menu.
9.5.3. Comm Loss
1． Tap <MODE/ESC>button ， access the main menu ， Press the <Up/Down>button
until“Communication”is displayed. Press <ENTER>. Tap the <Up/Down>button until“Comm
Loss”is displayed. Press ENTER.
2． Press <Up/Down>, until the display shows “No Fade on Loss”, “Fade out 30 seconds” or “Fade
out 60 seconds”.
3． Press ENTER to confirm or press <MODE/ESC> to return to the main menu.
9.6. Info
9.6.1. Software Version
With this function, you can display the software version of the device.
1． Tap <MODE/ESC>button，access the main menu，Tap the <Up/Down>button until“Info”is
displayed. Press ENTER.
2． Press <Up/Down>, the display will show “SoftwareVersion”.
3． Press< ENTER>, the display will show “SoftwareVersion”.
4． The display show “Ver x.x.x”.
5． Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
9.6.2. ARTNET IP
1． Tap <MODE/ESC>button，access the main menu，Tap the <Up/Down>button until“Info”is
displayed. Press ENTER, the display will show “Info”.
2． Press <Up/Down>, until the display shows “ARTNET IP”.
3． Press< ENTER>, the display will show “ARTNET IP”.
4． The display will show “ARTNET IP XXX. XXX. XXX. XXX”
“SUB NET XXX.XXX.XXX.XXX”
5． Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
9.6.3. Cross load Software
1． Tap <MODE/ESC>button，access the main menu，Tap the <Up/Down>button until“Info”is
displayed. Press ENTER.
2． Press <Up/Down>, until the display shows “Cross load SW”.
3． Press< ENTER>, the display will show “Cross load SW”.
4． The display show “OFF”, Press <Up/Down>, the display will show “ON”.
5． If “ON” is selected a Password is required. The password is 050
6． Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
9.6.4. Total Run Time
With this function, you can display the running time of the device. The display shows “XXXXh”,
“XXXX” stands for the number of hours.
1． Tap <MODE/ESC>button，access the main menu，Tap the <Up/Down>button until“Info”is
displayed. Press ENTER. Tap the <Up/Down>button until the display shows “Total Run Time”.
Press ENTER, the display will show “Total Run Time”.
2． The display will show “XXXXh” (Hours).
3． Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.