Mio X-Series User Guide Page 6
Touch Panel
The interactive Touch Panel on the front of the mioXM controls several functions of the
interface and displays status on eight LEDs.
Top Row LEDs
The top row LEDs illuminate whenever there is activity on any of the I/O ports:
• USB-DAW (USB MIDI between mioX and your computer)
• RTP-MIDI (RTP/Network MIDI)
• DIN-MIDI (MIDI on DIN Ports)
• USB-MIDI (MIDI on USB Host Ports)
When the mioX transmits data to another device, the corresponding LED will light up green.
When the mioX receives data from another device, the corresponding LED will light up red.
For example: If mioX receives USB MIDI from a connected computer, the USB-DAW LED will
light red. If mioX transmits MIDI out any of the DIN-MIDI ports, the DIN-MIDI
LED will light green.
Bottom Row Controls
The bottom row of the Touch Panel features four touch-sensitive controls, each of which will
load a memory preset (Mem 1 through Mem 4). When you touch the area of a control, the
mioX loads the appropriate memory preset and updates its bottom row LEDs to indicate the
currently active memory.
Note that only one Mem LED will light at a time. The LED color will usually be green, indicating
the preset is loaded and has not been edited by Auracle for X-Series or other control
software. Once a preset has been edited, the LED will turn red; this is to remind you to save
your work before loading another preset. If you do save the preset, or load a new one, the
appropriate LED will turn green.
Front I/O Jacks
The front of the mioXM features several ports that communicate by various MIDI protocols.
To Next Page
Loading...
