ICS 680GC - Guidebar and Diamond Chain Installation; Installation Steps and Spacer Removal

© 2012 ICS, Blount International Inc. Specications are subject to change without notice. REV020212 F/N 545353
TITLE680GC OPERATOR’S MANUAL
9
SET-UP
STEP 1
Loosen side cover nuts and remove side
cover.
GUIDEBAR AND DIAMOND CHAIN INSTALLATION
STEP 4
Mount the diamond chain on the guidebar
starting at the drive sprocket and continue
over the guidebar nose.
STEP 2
Remove shipping spacer.
STEP 5
Install the side cover and nuts. Do not
fully tighten side cover nuts until chain is
properly tensioned.
STEP 3
Place guidebar onto studs and chain
adjustment pin.