ICS 890 Series - Symbols & Labels

© 2014 ICS, Blount International Inc. Specications are subject to change without notice. REV021414 F/N 566100
890 SERIES OPERATOR’S MANUAL
4
SYMBOLS & LABELS
THE FOLLOWING SYMBOLS AND DEFINITIONS ARE FOUND THROUGHOUT THIS MANUAL
AND ARE DESIGNED TO MAKE YOU AWARE OF POTENTIAL HAZARDS OR UNSAFE
PRACTICES
A potentially hazardous situation exists which, if not avoided,
could result in death or serious injury.
A potentially hazardous situation exists which, if not avoided,
may result in minor or moderate injury or property damage.
A potential situation exists which, if not avoided, may result in
product or property damage.
THE FOLLOWING SYMBOLS & LABELS MAY BE FOUND IN THIS MANUAL OR ON THE SAW
Read the operator’s manual carefully and understand
the contents before you use this equipment.
Always use:
• Protective helmet
• Ear protection
• Protective glasses or full face protection
Wear hand protection
IMPORTANT
WARNING
CAUTION
� WARNING
• Do not exceed the hydraulic flow for your saw model
8 gpm (30 lpm) or 12 gpm (45 lpm) hydraulic flow or
2500 psi (172.5 bar) hydraulic pressure.
• Do NOT insert tool into slot narrower than chain.
• Do NOT run the saw backwards. The chain should travel
away from the operator on the top of the bar and return
on the bottom of the bar.
• Do NOT operate tool without solid footing and firm hand grip.
• Failure to observe these precautions can result in serious injury.
• Fluids escaping under pressure can penetrate the skin.
� WARNING
• Do NOT operate saw without side cover.
• Do NOT operate saw without baffle drain.
• Do NOT use this saw cover on any other saw model.
• Failure to observe these precautions can result in serious injury.