ELECTRONIC DIGITAL CONTROLLER
UNDERSTANDING THE ELECTRONIC DIGITAL CONTROLLER
The cabinet is fitted with an electronic digital controller. The electronic digital controller operation
diagrams below explain the primary functions of the cabinet. Refer to the key at the bottom of this
page for more information.
If you need to adjust the temperatures, please contact the ICS PACIFIC
Service Department on (Toll Free) 1800 630 360 for assistance.
To operate the light
1. To switch the light on or off press the UP / Light Button.
Reading and Resetting the High/Low temperature readings
1. To read the highest temperature the fridge has reached press the HI/LO Button
once. The high temperature will flash on the display.
2. To read the lowest temperature the fridge has reached press the HI/LO Button
again within 10 seconds of checking the high temperature. The low temperature will
now flash on the display.
3. To clear and reset these values press the HI/LO Button and hold it in for 6 to 7
seconds. The reset will be signalled by one long beep.
4. Every time the high and low temperatures are checked it is important to clear and
reset the displayed values.
Alarm function
1. The alarm will activate if the temperature inside the fridge goes below 2ºC or rises above
8ºC for longer than 30 minutes. The alarm will activate and the display will flash.
2. To mute the alarm, press the DOWN button. See “Special points to note” Point 15.0. The
display will continue to flash until the fridge returns to its normal operating temperature
range of between +2ºC to +8ºC.
3. Trouble shooting - in the event of the alarm activating check:
- The door is properly closed.
- The fridge has adequate ventilation – Refer “Special points to note” Point 10.0
- The fridge is stocked correctly - Refer “Set Up” (Page 4).
4. If the alarm is still activated after checking all the above contact the ICS PACIFIC
service department
Toll Free 1800 630 360 and quote the serial number of the fridge.
Please note: Please be aware that if a technician is sent and no
warranty fault is found there will be a service charge.
To Next Page
Loading...