General information
Changing the RAID mode will cause data lost.
Please refer to the instructions when switching the RAID mode, otherwise set up might fail.
When using RAID function, HDDs with the same brand, model and capacity is strongly recommended.
When using RAID function, more than one HDD partition is not recommended.
Under Windows
®
, users can enable GPT when initializing drives with a total capacity of more than 2 TB.
If users enable MBR by mistake, in order to clean the partition table, you have to switch to another RAID mode and do
the RAID mode switch all over again referring to Setup. Then go back to the RAID mode you want, repeat the previous
actions and enable GPT when initializing drives.
For macOS
®
users: the total capacity of more than 2 TB could be recognized only for the operation system is 10.4.11
Tiger or later.
Rebuild time is based on the capacity, e.g. it takes about 1 hour for 200 GB.
When the USB cable is plugged out, the device goes to sleeping mode automatically.
To take the HDD out from the device, slightly press down the handle and pull it out.
Setting up motherboard‘s power management in S3 is recommended. (For more details, please refer to
the user guide of motherboard BIOS setting).
If the device takes too long to initialize, please check if the drive is securely installed.
If there is noise with the fan, power off the device, unscrew the fan, take out the cover, clean the fan
and assemble it back.
Manual IB-RD3741-C31
To Next Page
Loading...
Need help?
General