AMC Commands and Responses
The following sections describe the commands that the host can send to the reader, this
is followed by a section describing the reader responses to the host. There are three
groups of commands, which can be sent to the reader. The first is used to manipulate the
reader (LED’s, status, etc.). The second is used to read and process magnetic stripe
data. The third group is used to write magnetic stripe data. Table 1, Table 3 and Table 4
summarize the commands of each group.
The unit executes commands received from the host one at a time and cannot execute a
new command until the previous command has been completed. Once the unit receives
a command, it performs the requested action and reports the results back to the host.
Unless otherwise specified, the examples shown assume that the unit uses the default
settings.
Reader Commands
To Next Page
Loading...
