To comply with the Bu ilding Regulations, each section must have a tick in o ne or other of the boxesCONTROLS
BOILER SERIAL No. NOTIFICATION No.
BENCHMARK No.
FOR ALL BO ILERS CONFIR M THE FOLLOWING
FOR THE CENTRAL HEATING MODE, MEASURE & RECORD
FOR COMBINATION BOILERS ONLY
FOR THE DOMESTIC HOT WATER MODE, MEASURE & RECORD
FOR CONDENSING BOILERS ONLY CONFIRM THE FOLLOWING
FOR ALL INSTALLA TION S CONFIRM THE FOLLOWING
COMMISSIONING ENG’S NAME
GAS BOILER COMMISSIONING CHECKLIST
TIME & TEMPERATURE CONTROL TO HEATING
TIME & TEMPERATURE CONTROL TO HOT WATER
HEATING ZONE VALVES
HOT WATER ZONE VALVES
THERMOSTATIC RADIATOR VALVES
AUTOMATIC BYPASS TO SYSTEM
ROOM T/STAT & PROGRAMMER/TIMER
CYLINDER T/STAT & PROGRAMMER/TIMER
PROGR AMMABLE ROO MSTAT
FITTED
COMBI BOILER
NOT REQUIRED
FITTED NOT REQUIRED
FITTED
FITTED NOT REQUIRED
THE SYSTEM HAS BEEN FLUSHED IN ACCORDANCE WITH THE BOILER MANUFACTURER’S INSTRUCTIONS ?
THE SYSTEM CLEANER USED
THE INHIBITOR USED
GAS RATE
BURNER OPERATING PRESSURE (IF APPLICABLE)
CENTRAL HEATING FLOW TEMPERATURE
CENTRAL HEATING RETURN TEMPERATURE
m
3
/hr ft/hr
N/A mbar
°C
°C
HAS A WATER SCALE REDUCER BEEN FITTED?
WHAT TYPE OF SCALE REDUCER HAS BEEN FITTED?
YES NO
GAS RATE
MAXIMUM BURNER OPERATING PRESSURE (IF APPLICABLE)
COLD WATER INLET TEMPERATURE
HOT WATER OUTLET TEMPERATURE
m
3
/hr ft/hr
N/A mbar
°C
°C
WATER FLOW RA TE lts/min
THE CONDEN SATE DRAIN HAS BEEN INSTALLED IN ACCOR DANCE WITH
THE MANUFACTURER’S INSTRUCTIONS?
YES
THE HEATING AND HOT WATER SYSTEM COMPLIES
WITHPARTS4&7OFTHEBUILDINGREGULATIONS
THE APPLIANCE AND ASSO C IATED EQ U IPMENT HAS BEEN INSTALLED AND COMMISSIONED
IN ACCORDANCE WITH THE MANUFACTURER’S INSTRUCTIONS
IF REQUIRED BY THE MANUFACTURER, HAVE YOU RECORDED A CO/CO
2
RATIO READING? CO/CO
2
RATIOYESN/A
THE OPERATION OF THE APPLIANCE AND SYSTEM
CONTR OLS HAVE BEEN DEMONSTRATED TO THE CUSTOMER
THE MANUFACTURER’S LITERATURE HAS BEEN LEFT WITH THE C USTOMER
PRINT CORGI ID No.
SIGN DATE
To Next Page
Loading...
