S
False clamp plate:
A clamp plate (A) is tted to the machine to
prevent pressure marks on sensitive material.
To dismount:
• Remove the clamp plate (A) by turning the
screwdriver (found in tool box) in the space
between the clamp and clamp plate.
• Store the clamp plate in the provided holder
(B).
The remaining cut, without false clamp,
is 20 mm
Warning!
Make sure the false clamp is in the
provided holder otherwise the
measurement from 20 mm - 90 mm
cannot be cut.
To mount:
• The clamp plate (A) is inserted to the top
into the clamp (C).
The remaining cut, with false clamp,
is 90 mm
•
Operation •
Airtable:
It is easier to position large stacks of paper
when the airtable
I is
switched on.
Setting clamping pressure:
The clamp pressure can be adjusted using
the adjustment knob
G. The
clamping pressure can be
read on the light panel
S.
To Next Page
Loading...
