EasyManua.ls Logo

IDEAL 7260 - Page 26

IDEAL 7260
52 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 26 -
W
• Operation •
Adapting a program when the printer’s
imprint deviates
• Press PROG RUN "Load program no."
appears
• Enter program number 01 ... 99, and with
2 x Enter
proceed to Step 1
• Correct the cutting position of the backgauge
with the hand-wheel
• MODIFY W appears on the screen and the
measurement ashes
• To store press MODIFY
• Release a cut and turn the paper
• If the printer’s imprint deviates it can be
corrected during the rst two cuts via the
hand-wheel – see above
• Correction is only possible during the rst
two cuts
• After leaving the PROG RUN mode the
original data is stored again.
Delete a step
• Press PROG EDIT
• Enter program number, conrm with Enter
• Select program step with the arrow keys
b and j
•
Scroll with STEP until "Delete step no."
appears, Press 2 x Enter
.
Insert a step
• Press PROG EDIT
• Select a program, conrm with Enter
• Scroll with STEP until "Insert step no."
appears
• Enter insert position e.g. 02
• Conrm with Enter
• Enter a measurement
• Store the measurement with
• The cutting position can be shown on the
screen with the arrow keys
b and j.
Changing a program step
• Press PROG EDIT
• Select a program, conrm with Enter
• Scroll with STEP until "Load step no."
appears
• Enter step position e.g. 03
• Conrm with Enter
• Enter a new measurement, Store the
measurement with
.