- 27 -
Y
X
Z a
Q
R
T
Eject function program
• If a short measurement e.g. 30 cm and then
a long measurement e.g. 40 cm is cut at the
start of a program then it is wise to insert an
EJECT
X after the rst cut so that the paper
is pushed to the front.
• The EJECT function can be added each time
a measurement is entered and ejects before
advancing to the next measurement. When
the eject function is programmed an "E"
X
appears top right in the display.
• Inserting an Eject function subsequently in
the program. Select a program and advance
to the step to be changed with the arrow
keys
b and j Enter the new
measurement and before activating the
enter button
press EJECT Y .
Example of a program eject function
• Press PROG EDIT
• Enter program number e.g. 08
• Press Enter
• 1. Enter program Step e.g. 30 cm
• Press Enter
• 2. Enter program Step e.g. 40 cm
Press EJECT and with Enter
store the
dimension.
How the example works
• Press PROG RUN
• Enter program number 08
• Press Enter ,
• Press START, Measurement is approached
• Insert paper
• Release cut 1
• Eject (Ejection is completed, turn the paper)
• The backgauge moves to program step 2
• Release cut 2
Multiple cut program
• Press PROG EDIT
• Enter program number
• Enter the 1. program step e.g. start-up
measurement 40 cm
• Store the measurement with Enter
• Press the multiple cut symbol T
• Enter the number of cuts Z with the + button
a (max. 15 cuts) followed by the multiple cut
size (cutting width).
• Store with Enter .
• Operation •
To Next Page
Loading...
