Verifying Continuity ( ) Measuring AC ( ) or DC ( ) Current (Amps)
• Verify the circuit is de-energized.
• The meter will sense the level of resistance and a beep if the resistance is less than
10 Ω to confirm that continuity is present.
• Red LED will illuminate and resistance value will be displayed.
• The default setting is continuity.
Verify the circuit is de-energized to obtain accurate measurements.
Measuring Resistance (Ohms / Ω )
15
Measuring AC ( ) or DC ( ) Voltage
To exit Continuity and enter
the resistance mode, press the
SEL Button
To Next Page
Loading...
