Dear customer:
Thank you very much for purchasing our SALT ELECTROLYSIS SYSTEM for the treatment
of swimming pool water. IDEGIS SALT ELECTROLYSIS SYSTEMS have been designed and
manufactured taking into account the already existing specific necessities in the treatment of
the swimming pool water. Their main features are handling simplicity and easy installation,
together with low maintenance costs.
Before installing and using the equipment, please read this Operation Manual carefully and
keep it for future reference.
DESCRIPTION OF THIS OPERATION MANUAL
This Operation Manual describes the operation of model D-40; as well as models with
INTEGRATED PH/ORP CONTROLLER, D-10+, D-18+, D-25+ and D-40+.
UNPACKING
Verify the following elements of the installation kit have been included in the package, and
read the whole Operation Manual before starting the installation of the unit.
Supplied elements:
Power supply (with integrated pH/ORP controllers ).
Electrolysis cell.
Models D-10+ ... D-25+.
Models D-40(+)
Calibration solutions [pH=4.0 (red) / pH=7.0 (green) / 470
mV ORP].
H-035 pH-electrode (blue).
PE holder 12mm -1/2”G for pH/ORP electrode insertion (x
2).
Connector CEE22 for dosing pump (dosing pump and
accessories not supplied).
RX-02 ORP electrode (red)
.
BEFORE INSTALLATION:
Before installing the IDEGIS SYSTEM or performing any
maintenance task, please disconnect the 220 Vac voltage
supply:
o System must be installed by qualified personnel, in
accordance with all local and national electrical regulations.
o Verify that the supply voltage corresponds with the one
indicated in the label located in the left side of the unit.
o Check all the electrical connectors are well tightened to avoid false contacts and their consequent
overheating.
o Do not connect the unit to the 220 Vac voltage supply before connecting the electrolysis cell to the
power supply. Choose an installation place where the system can be easily accessed, allowing an easy
inspection of the control panel and the electrodes.