Idegis DOM-12 PH - Page 5

32 pages

To Next Page

To Previous Page

Fig.2 Recommended installation diagram (DOMOTIC Series DOM-XX PH and DOM-XX PLUS).

Main Page

Contents of the Pack2
General Features2
Safety Precautions2
Power Supply3
Electrolysis Cell3
PH/ORP Control3
Recommended Installation Diagram4
Installation of the Power Supply6
Installation of the Electrolysis Cell6
Electrical Connection of the Electrolysis Cell7
Recommended Installation7
Allowed Installation7
Not Allowed Installations7
Installation of the Ph / ORP Sensors8
Installation of the Optional External Flow Detector8
Install the Ph/Orp Sensors Vertically or with Max Inclination of 408
Installation of the Removable Control Terminal9
Poolstation Connection9
Controls and Indicators11
DOMXX-PH Models Control Panel11
DOM-XX PLUS Models Control Panel12
Optional External Flow Detector Control13
Automatic Cover Control13
Start-Up14
Orp/Residual Chlorine14
System on Stand-By15
System Configuration15
System Programming Flow-Sheet16
Production Level Selection17
Salinity Test17
Integrated Ph Controller18
Connection of the PH/ORP Sensors18
Connection of the Dosage Pump18
PH Setpoint Programming18
ORP Setpoint Programming19
Safety Stop Configuration of the Dosage Pump19
Alarms20
High Salt Level20
Low Salt Level20
Water Level in Cell/Flow Detector21
Optional External Flow Detector/Flow Switch21
Submerged Gas Detector. System Running.21
Gas Detected. Insufficient Flow. System Off.21
Electrodes22
PH/ORP out of Range22
Maintenance of the Electrolysis Cell23
Calibration of the Ph Sensor23
“FAST” Mode23
Procedure23
“Standard” Mode24
Calibration of the ORP Sensor25
Error Messages25
PH/ORP Sensors Maintenance26
Troubleshooting27
Components28
Power Supply28
Technical Characteristics29
Technical Specifications29
General Features29
Dimensions30
Domotic30
DOMOTIC-Ph/Plus30
General Aspects31
Specific Conditions31

Idegis DOM-12 PH - Page 5

Table of Contents

Related product manuals