Reader can be powered from POE. Communication happens through Ethernet also, but not
evaluated by UL.
This is the default reader behavior in a standalone condition.
6.0 Product Label
- SHIELD – should be connected to the cable shield.
Caution:
During wiring, make sure that the PWR lines does not contact any other conductors, as it might affect
reader functionality / cause damage to the reader.
7.0 Installation
All cabling and wiring shall be UL Listed and/or UL Recognized.
• Install the required mounting box to the wall
• Take the cable from the rear side of the reader as per the pin outs in the label drawing
• Secure the reader unit with four screws at the corner into the mounting box
• Fix the bezel on the top of the casing
To Next Page
Loading...
