iDevices IDEV0008 - Single Pole Wiring Installation; Single Pole Installation Steps

8 9
INSTALLATION - SINGLE POLE
STEP 1
Turn off the power at the circuit breaker.
STEP 2
Remove the existing switch from the gang box.
STEP 3
Conrm that each gang box contains a neutral wire (typically white).
If there are no neutral wires present, you may need to run additional
wires, please consult a qualied electrician.
NOTE: Your home’s wiring may differ; please consult a qualied electrician.
LOAD
LINE
NEUTRAL
LINE
GROUND
LOAD