DOC No: PN 86880 REV A
5
STANDARD LIMITED WARRANTY
The products manufactured by Micropump Incorporated are warranted to be free
from defects in workmanship and material at the time of shipment from the place of
manufacture. Micropump will repair or replace, at its option, any part or component
which fails to conform to this warranty for a period of one year. Micropump’s
obligation under this warranty is limited to the repairs or replacement of defective
equipment returned to Micropump on an F.O.B. destination and freight-prepaid
basis. All normal wear and tear is excepted, and product is subject to examination at
Micropump to verify that the parts or components were defective at the time of sale.
For the purposes of the limited warranties, the “Stator/Controller Assembly” means
only the stator and the printed circuit board and electronic components contained
in the controller housing, plus the connecting control and power cables. The
“Power Supply Assembly” means only the printed circuit board and the electronic
or mechanical components located inside or on the power supply enclosure and
the “Pump head Assembly” means all other parts of the product, including but not
limited to, the rotor.
No warranty of any kind is made or shall be imposed with respect to any pump or
parts (1) that have not been properly installed and tested in operation, (2) that have
been subject to misuse, negligence, acts of God or the elements, or any other form
of casualty, or (3) that have been repaired or altered outside Micropump’s facility in
a way, so as, in our judgment, to aect performance or reliability.
The parties agree that the buyer’s sole and exclusive remedy against Micropump
shall be for repair or replacement of defective parts under the conditions stated
above. The buyer agrees that no other remedy (including but not limited to
incidental or consequential damages for lost prots, lost sales, loss of use, injury
to person or property, or any other incidental or consequential loss) shall be
available to them.
This warranty shall not apply to prototype pumps, experimental pumps, or
brush-type electric motors. Warranty of equipment or accessories from outside
sources, purchased by Micropump and incorporated into Micropump’s product
is subject to the manufacturer’s standard warranty, unless specically agreed
otherwise between Micropump and buyer. A copy of the warranty on the
aforementioned equipment is available on request.
The adjustment or replacement of defective parts made under this warranty will
not extend the original warranty period.
THE WARRANTY DESCRIBED ABOVE IS THE EXCLUSIVE
MICROPUMP WARRANTY AND IS IN LIEU OF ALL OTHER
WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING ANY
WARRANTY OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE OR ANY WARRANTY PREVIOUSLY
ISSUED. WE NEITHER ASSUME NOR AUTHORIZE ANY PERSON
TO ASSUME FOR US ANY OTHER LIABILITY IN CONNECTION
WITH THE SALE OR USE OF OUR EQUIPMENT.
To Next Page
Loading...
Need help?
General
