IDS Xwave

700-604-02A Xwave Repeater Manual
Thank you for purchasing the Xwave repeater. The repeater works on the 433Mhz frequency
range and only repeats the signals from a known Xwave device. The unit can also indicate that
signals are being repeated by turning on the button that corresponds to the channel being
repeated or a beep each time a signal is repeated.
Figure 1: Xwave repeater
A.
B. C.
Beep when a signal
is repeated
Show channel
being repeated
Wireless channels
Not used
Not Used
Battery charging
indicator
Transmit Indicator
Housing Screw
DC Charging
Plug
Stand
Open

IDS Xwave Specifications

General

Brand	IDS
Model	Xwave
Category	Receiver
Language	English

Summary

Adding Batteries

Learning Detectors into a Channel

Delete a Channel

Visual Indications

Chime on Repeat

Repeater chimes and flashes LEDs to indicate which channel's signal is repeated.

Visual Indication on Repeat

Repeater uses visual indicators (LEDs) to show if a channel's signal is being repeated.

Information LED

Important NiMH Battery Charging Considerations

Technical Specs