9
3. Get started
This chapter provides information about installing,
connecting, and using your scanner.
3.1. Installation
Install your scanner with the steps below.
3.1.1. Set Up Your Scanner
1. Plug the RJ45 connector into the scanner’s RJ45 port,
until it clicks.
2. Insert the USB connector to your computer.
3. Turn on your computer. It will autodetect your
scanner.
4. To test your scanner, start a text editing program like
Notepad or Microsoft Word. Scan a bar code to see if
the scanner can send data to your computer. If it’s
successful, you’ll hear a beep and see the bar code
data in the text editing program.
To Next Page
Loading...
