Innovative DisplayWorks
GCG-10
CONDENSER MAINTENANCE
It is essential to keep the condenser coils clean and free of dust and debris at all times. It is required to periodically clean
the condenser coils with a soft bristle brush or vacuum-cleaner to properly maintain the refrigeration system. Failure to
clean the condenser at regular intervals may cause failure of the refrigeration system and could void the warranty.
1 Remove the rubber cap from the front Grill.
2 Using a small Phillips head screwdriver, remove the two screws as shown above.
3 The front plastic grill can now be removed by pulling it up.
4 Using plastic bristle brush, carefully clean the coil being aware that coils
can bend or be damaged if too much force is used - shown below.
5 Replace grill and utilize the Phillips screwdriver to tighten the screws into
place, replace the rubber caps.
10
MAINTENANCE
Cleaning
• Unplug the cooler before cleaning.
• Use a soft cloth or sponge with water or soap (non-corrosive mild detergent). After cleaning, wipe the cooler using a
dry cloth to prevent the cooler from rusting.
• Do not spray water on the cooler, and do not use hard or steel brushes to clean the cooler.
• Do not use organic solvents, boiling water, washing powders or acids while cleaning.
If the cooler will be in a non-operational state for a long period of time, clean as
instructed above, and keep the door open until interior is dry.
To Next Page
Loading...
Need help?
General
