EasyManuals Logo

IEC CPY 08 User Manual

Default Icon
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
Fan Coils
INSTALLATION, OPERATION, & MAINTENANCE MANUAL
5
SECTIONONE—Receipt&InitialInstallation,Cont’d.
SalesRepresentativeshouldbenotiedimmediatelyso
thatproperactionmaybetaken.
NOTE: Shouldanyquestionsariseconcerningwarrantyrepairs,the
factorymustbenotiedBEFOREanycorrectiveactionistaken.
Wherelocalrepairsoralterationscanbeaccomplished,
thefactorymustbefullyinformedoftheextentand
expectedcostofthoserepairsbeforeworkisbegun.
Wherefactoryoperationsarerequired,thefactorymust
becontactedforauthorizationtoreturnequipmentanda
ReturnAuthorizationNumberwillbeissued.Unauthorized
returnshipmentsofequipmentandshipmentsnotmarked
withanauthorizationnumberwillberefused.Inaddition,
anyclaimsforunauthorizedexpenseswillnotbeaccepted
bythemanufacturer.
Handling and Installation
Whileallequipmentisdesignedandfabricatedwith
sturdymaterials,andmaypresentaruggedappearance,
greatcaremustbetakentoassurethatnoforceor
pressurebeappliedtothecoil,pipingordrainstub-
outsduringhandling.Also,dependingontheoptions
andaccessories,someunitscouldcontaindelicate
componentsthatmaybedamagedbyimproperhandling.
Whereverpossible,allunitsshouldbemaintainedinan
uprightposition,andhandledbythechassis,plenum
sections,orascloseaspossibletothemounting-point
locations.Inthecaseofafullcabinetunit,theunitmust
obviouslybehandledbytheexteriorcasing.Thisis
acceptableprovidingtheunitisagainmaintainedinan
uprightposition,andnoforceisappliedthatmaydamage
internalcomponentsorpaintedsurfaces.
TheequipmentcoveredinthismanualIS NOTsuitable
foroutdoorinstallations.Theequipmentshouldneverbe
storedorinstalledwhereitmaybesubjectedtoahostile
environmentsuchasrain,snow,orextremetemperatures.
Before,during,andafterinstallation,specialcaremustbe
takentopreventforeignmaterialsuchaspaint,plaster,
anddrywalldustfrombeingdepositedinthedrainpanor
onthemotororblowerwheels.Failuretodosomayhave
seriousadverseeffectsonunitoperation,andinthecaseof
themotorandblowerassembly,mayresultinimmediateor
prematurefailure.Allmanufacturer’swarrantiesarevoidif
foreignmaterialisallowedtobedepositedinthedrainpan
oronthemotororblowerwheelsofanyunit.Someunits
and/orjobconditionsmayrequiresomeformoftemporary
coveringduringconstruction.
Installation Instruction for Ceiling Hung Units
Anchoringtheequipmentinplaceisaccomplishedby
usingthemountingpointsprovidedwith3/8”or1/2”
allthread(notsuppliedwithunit).See Figure 1 for
recommended all-thread diameter.Theunitmustbe
positionedsothatthedrainpanisonaLEVELPLANE.
Caremustbetakentoinsurethatthedrainpandoesnot
slopawayfromtheoutletconnection.Horizontalopen
coilunitmodelsHHYorFHYmaybemountedusingthe
neoprenegrommetsprovided.Plenum-typeunitmodels
HPYorCPYmaybemountedusingthefourgrommetsin
thecoilsection,ortherearcoilsectiongrommetsmaybe
removedtotheplenumhangerbrackets.Hi-performance
cabinetunitmodelsHLYorHXYmustbemountedusing
theslottedhangerrailsprovided.(Grommetsarenot
furnishedfromthefactory).
Othereld-furnishedmountingdevicessuchasrubber-
in-shearorspring-typevibrationisolatorsselectedbythe
contractororengineermaybesubstitutedforthefactory
grommets,andshouldbeusedwherefactorygrommets
arenotprovided.
Itshouldbenotedthatunacceptablesystemoperating
characteristicsand/orperformancemayresultfrom
improperorinadequateunitstructuralsupport.Inaddition
adequateclearancemustbeprovidedforserviceand
removaloftheequipmentanditsaccessorycomponents.
Figure 1. Threaded Rod Recommendations
Model Rod Diameter Rod Qty
C*Y02,03,04,06,08,10,12 3/8” 4
H*Y06,08,10,12,14,16,18,20 3/8” 4
H*D06,08,10,12,16,20,30,40 1/2” 4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IEC CPY 08 and is the answer not in the manual?

IEC CPY 08 Specifications

General IconGeneral
BrandIEC
ModelCPY 08
CategoryAir Conditioner
LanguageEnglish

Related product manuals