Why IECHO Cutter suction force weakened and materials aren't fixed well?
If your IECHO Cutter's suction force has weakened, preventing materials from being fixed well, consider the following: * If the materials are breathable, place a piece of plastic film on their surface. * If the vacuum entrance filter net is blocked, clean it. * Inspect the vacuum plate and pipes for any leaks.
What to do if IECHO BK4-2516 Cutter materials couldn’t cut though?
If materials aren't cutting through on your IECHO Cutter, it could be due to a few reasons: * **Knife height:** Increase the cutting knife depth. * **Blade condition:** Change to new blades. * **Table flatness:** Check the flatness of the cutting table. * **Material adherence:** Place a piece of perforated paper on the table surface if materials aren't cutting off completely.
How to troubleshoot IECHO BK4-2516 that cannot start?
If your IECHO Cutter isn't starting, check the following: * Ensure the circuit breaker hasn't tripped. * Verify the fuse isn't burned out. * Confirm the red switch isn't broken. * Check the plug connected to the electrical box interface using a multimeter. * Examine the circuit of the 220V power.
How to fix IECHO BK4-2516 not cutting off patterns at the corners?
If your IECHO Cutter is not cutting off patterns at the corners, open the Cutter Parameter Setting dialogue box and reset the Knife Up Compensation and Knife Down Compensation.
Lists key features and benefits of the BK4 series cutting machine.
Details the main components and modules of the BK4 series machine.
Explains the operational flow from file import to motion control signals.
Provides detailed specifications like dimensions, speed, accuracy, and power requirements.
Describes the types of cutting heads, including Universal and Punch heads.
Details various cutting tools like Tangent, EOT, V-CUT, and their applications.
Shows the location of circuit boards within the electrical box for identification.
Covers initial setup steps like loading, unloading, and leveling the machine base.
Explains the requirements and connection procedures for the machine's power supply.
Details the air source interface and connection for operating the cutting system.
Provides step-by-step instructions for mounting cutting heads onto the machine carriage.
Guides the user on how to install various cutting tools like UCT, EOT, and V-CUT.
Outlines essential checks and preparations before starting the cutting machine.
Describes the procedure for powering on, resetting, and commencing the cutting process.
Presents the overall electrical wiring diagram for the BK4 machine.
Illustrates the pneumatic (gas) circuit diagram for the BK4 cutting system.
General| Model | BK4-2516 |
|---|---|
| Cutting Area | 2500mm x 1600mm |
| Max Cutting Speed | 1200mm/s |
| Max Cutting Thickness | 50mm |
| Material Fixing Method | Vacuum Adsorption |
To Next Page
