Why IECHO BK4 Cutter suction force weakened and materials aren't fixed well?
If your IECHO Cutter's suction force has weakened, preventing materials from being fixed well, consider the following: * If the materials are breathable, place a piece of plastic film on their surface. * If the vacuum entrance filter net is blocked, clean it. * Inspect the vacuum plate and pipes for any leaks.
What to do if IECHO Cutter materials couldn’t cut though?
If materials aren't cutting through on your IECHO Cutter, it could be due to a few reasons: * **Knife height:** Increase the cutting knife depth. * **Blade condition:** Change to new blades. * **Table flatness:** Check the flatness of the cutting table. * **Material adherence:** Place a piece of perforated paper on the table surface if materials aren't cutting off completely.
How to troubleshoot IECHO BK4 Cutter that cannot start?
If your IECHO Cutter isn't starting, check the following: * Ensure the circuit breaker hasn't tripped. * Verify the fuse isn't burned out. * Confirm the red switch isn't broken. * Check the plug connected to the electrical box interface using a multimeter. * Examine the circuit of the 220V power.
How to fix IECHO BK4 Cutter not cutting off patterns at the corners?
If your IECHO Cutter is not cutting off patterns at the corners, open the Cutter Parameter Setting dialogue box and reset the Knife Up Compensation and Knife Down Compensation.
Installation, use, and maintenance should only be completed by qualified professionals.
Serious injury risk from unauthorized housing removal or incorrect installation/use.
Equipment modifications require prior consultation with Hangzhou IECHO Technology Co., Ltd.
Company is not liable for safety injuries caused by unauthorized accessories.
Overview of BK4 series cutting machine features, design, efficiency, and noise reduction.
Details the components of the BK4 series cutting machine and optional modules.
Explains the process from file import to motion control for high-speed, high-precision cutting.
Universal cutting head for various tools, max cutting thickness 50mm.
Punch head with two punches for round or V-shaped holes, max punching 10mm.
Universal cutting tool for materials up to 5mm thick, fast and low cost.
High-frequency electric-driven tool for soft/medium materials, 80W options.
Air-driven tool with extended stroke for dense materials up to 50mm thick.
For precise cutting of vinyl material, cutting upper layer without damaging the bottom.
Covers the process of installing the complete BK4 machine.
Instructions for safely loading and unloading the BK4 machine using a forklift or lifting device.
Procedure for installing the UCT (Universal Cutting Tool) into the machine head.
Procedure for installing the EOT (Electric Oscillating Tool) into the machine head.
Steps for installing the V-CUT tool blade and handle onto the cutter base and tool head.
Instructions for installing the creasing tool handle and buckling the pressure shaft.
Checks and preparations required before starting the cutting machine operation.
Sequence of actions for operating the cutting machine, including power on, reset, and material setup.
Detailed circuit diagram illustrating the electrical connections for the BK4 machine.
Troubleshooting steps for when the cutting tool fails to start.
Solutions for reduced cutter suction force affecting material fixation.
Troubleshooting for materials not being cut completely through.
Adjustments for accurately cutting patterns at corners.
Diagnosing and resolving issues with file transfer to CutterServer.
To Next Page
General