This document is the property of IER and may not be reproduced
or communicated without prior written authorization
2 READER CONNECTIONS
This product must exclusively be connected to an
electrical circuit provided with a ground fault circuit
interrupter (GFCI) and complying with IEC 364 and
NFC15-100 regulations.
Make sure the reader is switched off (power switch
set to the 0-position) and that the power cord is
disconnected.
It is vital to proceed in the order described.
To comply with class B FCC regulations it is
necessary to use a data cable provided with a braided
shield.
To Next Page
Loading...