The information contained in this document is the property of Automatic Systems and is confidential. The recipient shall refrain from using it for any purpose other than the use of the products or the
execution of the project to which it refers, and from communicating it to third parties without Automatic Systems’ prior written agreement. Document subject to change without notice.
BL5x-MT-EN-13 page 24/56
Open Cmd: if active, the obstacle opens.
If inactive (i.e., when the command is released), the obstacle
stops.
Close Cmd: If active, the obstacle closes. If inactive, it stops.
STOP Cmd: stop.
Note: the open or close command may be realised by a
Lock OP or Lock CL pulse command.
Note: the reader commands do not work in this mode.
Note: this mode is only compatible with presence sensors
operating under the Nothing_Stop or Deactivated modes
(otherwise the Incompatible message appears briefly).
Same as 2 Contacts operation, except:
Close Cmd: Closure of the obstacle on the Falling Edge of
the command (i.e., when the button is released).
This message is displayed for one second if the operating
mode selected is not compatible with the parameters set for
the presence sensors.
Save the parameter values (see the MEMORY menu).
Save the modified parameters in MEM1.
This saving action is necessary so that the
modifications made are not lost during a power cut!
Recall the default values (factory settings) of the parameters
accessible in the level from which this command is executed.
E.g.: If you are in the Simplified menus, this function will only
load the default values of the parameters accessible in
Simplified menu, and will not modify the values of the
parameters accessible in Extended or Manufacturer menus.
Warning: the loading of the default parameters entails
the loss of the parameters specific to the installation’s
real situation and may put the equipment out of service.
This message is displayed when the save or the load is
finished and disappears automatically after 1 second.
0000 0000 0000
(default) (default) (default)
to to to
1024 1024 1024
This parameter applies to the analogue sensor (see the
Positioning parameter above) and allows viewing the current
value of the sensor (Sensor) (reflection of the angular
position of the obstacle) in its measurement range (Min and
Max being the sensor values at the extreme positions of the
obstacle: completely open and closed).
Choice of the display mode for the menus.
Access to the menus included in the Simplified mode.
Warning: pressing the OK key to validate the passage
from the Extended to the Simplified mode causes a
movement of the arm (opening or closing), even if a
presence is detected by the Presence sensors.
Access to supplementary parameters.
To Next Page
Loading...