IFM AL1340 - Initial Set-up

IO-Link Master with Modbus TCP Interface DataLine 4 Ports IP 65 / IP 66 / IP 67
22
8 Set-up
Content
Read device and diagnostic information ................................................................................................23
52357
When the supply voltage is switched on, the AL1340 starts with the factory settings. The display
elements signal the current operating mode (→ Operating and display elements (→ S. 19)).
To enable parameter setting of the AL1340, the IoT interface and / or the fieldbus interface must be
configured according to the network environment.
► Configure IoT interface (LR DEVICE: → IoT: Configure IP settings (→ S. 27) or → Configure
IoT interface (→ S. 40)).
► Configure fieldbus interface (LR DEVICE: → Fieldbus: Configure IP settings (→ S. 31) or IoT:
→ Configure the fieldbus interface (→ S. 44)).
> IoT / fieldbus interface has valid IP settings.
> User can set the parameters of the AL1340.
Further steps:
 Optional: Update firmware of AL1340 (→ Update firmware (→ S. 77)).
 Set the parameters of the AL1340 (→ Configuration (→ S. 24)).