IFM AL1340 - Page 66

IO-Link Master with Modbus TCP Interface DataLine 4 Ports IP 65 / IP 66 / IP 67
66
>
9.3.3 Set IO-Link ports
34460
Register area for the access to the configuration of the IO-Link ports: →Configuration Area (→ S. 88)
The area contains the following data:
 Operating mode of IO-Link ports
 Device validation and Data storage settings
 Failsafe values of outputs
► Observe the general rules for access to the Modbus registers (→Rules for accessing the
Modbus registers (→ S. 73))!
► When writing several registers at conce, ensure that the transferred parameter data has
the correct length!
Register
Contents
Access
9000
Port X01: Port Configuration
r/w
9006
Port X02: Port Configuration
r/w
9012
Port X03: Port Configuration
r/w
9018
Port X04: Port Configuration
r/w
r/w = read and write
In addition, the user can set the IO-Link ports of the AL1340 via the following acyclic commands:
 "Set Mode": →Command 0x10 – Set mode (→ S. 104)
 "Set Validation ID / Data Storage": →Command 0x20 – Set validation ID / data storage
(→ S. 106)
 "Set Fail-safe Data Pattern": →Command 0x30 – Set fail-safe data pattern (→ S. 108)
The commands use the process mechanisms of the acyclic command channel (→Use acyclic
services (→ S. 75)).