Press the P3 key: D2 will flash. Pressing the same key again
will change the values. After 5 seconds the new value will be
active and you can see the selected value.
A long press on the P3 key will activate the manual pellet
loading and the fuel feed will run continuously. Bottom
Shows the loading, shows the time of loading on the up
screen. Press any button to stop the installation. The
installation will stop automatically after 300 seconds.
Pellet Loading
Correction
Pressing and holding the P2 button will activate this
function. (Repeat two times to make changes). The bottom
display shows PELL, the value appears in the screen above.
With buttons P2 / P4 the value can be increased or
decreased; the default value is ’0 varsayılan. After 5 seconds
the new value will be saved and return to the normal
display.
A long press on P4 will activate this function. (Repeat two
times to make changes). Uent appears on the lower display,
the value appears in the above screen. With buttons P2 /
P4 the value can be increased or decreased; the default
value is ’0 varsayılan. After 5 seconds the new value will be
saved and return to the normal display.
The instantaneous value is displayed on the lower display.
To Next Page
Loading...
