IFYIL GALATA - Page 71

An alarm condition was
observed on the display. The
keys were inactive.
• Any of the safety elements on the stove may have
been activated.
• Overheating
• Excessive water pressure
• Fuel may be exhausted.
• Door open
• Ignition failed.
• Refer to the code of the alarm status and a
description of the code in the instruction manual.
• Keep the on / off button pressed so that the stove
is self-controlled. If the fault is cleared, the stove
switches to the shutdown state. If the alarm
continues, the error continues.
• In case of overtemperature, turn the stove to off
and allow it to cool down. Then re-ignition.
• Reduce the pressure to less than 2 bar by
discharging water from the installation.
• Fill the fuel tank.
• Make sure the door is closed.
• After waiting for your stove to shut down, clean
the burner and re-ignition.
Oven does not heat up
• The smoke flap is in the wrong direction.
• The stove may not have entered the powers.
• The stove is switched off.
• Fuel may be exhausted.
• The direction of the flap should be to the left.
• Wait for the stove to pass.
• Re-ignite if the stove is switched off.
• Load fuel.
Oven is very hot
• Not at the desired power setting.
• Set the desired temperature using the flame
configurations from the control panel.