•
If the base where the stove is to be installed is made of flammable materials. If
the stove is put on flammable material, suitable isolation must be done.
•
Please keep away heat sensitive materials from stove (flammable, explosive
etc.).
4.2. Electrical Connections
First insert the power cable into the back of the stove, then insert the
cable outlet. Opening the back of the stove on / off
switch to turn on your
stove, bringing the open position.
A voltage regulator using is required in areas with voltage
irregularities. Electronic and electronic card
failures that may occur due to the absence of a
voltage regulator are not covered by the
warranty.
4.3. Ventilation And Air Flow
•
In the room where the stove is installed, there should be enough air to allow
regular combustion.
•
The location of stove fresh air inlet must be provided.
• It is recommended that the stove should be connected to an environment
(external environment) where the air suction pipe can be continuously flowing
clean air with hermetic pipe.
•
Use 300 cm² lower, 200 cm² upper orifice. These grilles should never be
closed. Otherwise, it presents a great danger.
To Next Page
Loading...
