•
Avoid installing the unit in the same environment with the following;
o
B type gas heaters or exhaust fan or fan less hoods
o
Collective ventilation pipes.
o
Aspirator device running in the same environment, can cause problems.
4.4. Chimney Instructions
➢
The main cause of the chimney fire;
• Improper selection or pipe that dust is flammable fuel.
• In the event of appropriate conditions can cause fires ignite in the ducts.
➢
Ways of avoiding them;
• The chimney should be cleaned at least 2 times per year, depending on
the fuel quality.
• Correct and appropriate chimney selection should be made.
• Ensuring that the sealing and smoke in the chimney pipe and must be
made in isolation.
• Fresh air intake area of the ducts that maintaining and cleaning the
stove is installed
• In case of a re-ignition after prolonged period of time, the smoke paths
and flue congestion must be checked.
• Surrounding the peak point of the roof of the chimney to the
interference of the obstacle (the ridge) from height must be at least 80
cm.
• Should chimney's pipe inner diameter is 80 mm.
• Chimney flue test should be performed before making connections. If
the chimney connections should be carried out after removal of the
traction problem had this problem in the chimney.
• The stove pipe connected to the horizontal flue pipe must not be longer
than 2m. It is recommended to use 45 ⁰ elbows in chimney pipes
instead of 90 ⁰ bend. (Site selection for stoves should be determined by
the closest point where the chimney.)
• To avoid turbulence around the chimney flue without any obstructions
(high buildings, trees, etc.) Must be at least 10 m away.
• The pellets stove should be mounted as close to the chimney as possible
(chimney connection should be short).
To Next Page
Loading...
