IFYIL THERMAL - Page 63

62
5) Press the P3 button to enter the change mode: the
selected value (hour or minute) blink. To change the
value, change the P3 key between hours and minutes
and increase / decrease with P2 / P4.
0 1 . 0 0
1
I
Mo
6) Save by pressing P3
2 1 . 3 0
1
I
Mo
7) Use the P2 key to select the Off Timer and repeat
the operations from point 5.
0 0 . 0 0
1
I
Mo
Each time setting can be adjusted with 15-minute time intervals.
Hour
(oroL)
This menu allows setting the time and date. The screen is displayed as
shown in the illustration.
Explanation
Display
Press the P3 button to enter edit. The selected value
(hour, minute, day) blink. Use P2 / P4 to change the
value.
Press the P3 button to change other parameters. Press
the P3 button again to save the set value.
07. 3 3
Mo
Comman
d (TELE)
This menu allows you to activate the remote control.
Cleaning
reset
(rCLr)
This menu using for reset of the “System Maintenance 2”
Technica
l Menu
(TPAr)
This menu provides access to the technical menu. Only the Technical
Service can access this menu and is protected by password.