IFYIL THERMAL - Pellet Feed and Combustion Issues; Alarm Display and Control Lockout

The pellets are fed
The pellets feeder is empty.
Drain and refill the pellets tank.
into the combustion
Pellets feeder screw
Sawdust pellets feeder manually
chamber or not that
(powder) to recover
comes less.
Sawdust (powder) was blocked
from obstructions such as screws.
by.
Motor defective.
Faulty electronic card
Call the technical service
The pellets are stacked into the
combustion pot, cover glass
gets dirty very quickly and the
flames are burning low.
comes insufficient combustion air.
Check that it is edible by the room constantly
fresh air.
The pellets could not damp or
appropriate.
Check the gutters clean and clear
the air duct of the combustion pot.
Smoke extractor engine may be
damaged.
Call the technical service
The display showed any alarm
condition. Keys were inactive.
in any of the security elements on the
stove.to be entered
On / off button while holding down the stove's
self-control switches off the stove if the error
corrected the stove goes into shutdown.
Alarm continues the error continues.
In case of extreme temperatures you expect
to take the stove to cool off position. Then
make a fire again.