IGEL Technology GmbH Hardware Manual IGEL UD3 / IZ3
2/10 Version 1.2 – March, 2019
Information
Copyright
This publication is protected under international copyright laws. All rights reserved. With the exception of
documentation kept by the purchaser for backup purposes, no part of this manual – including the products
and software described in it – may be reproduced, manipulated, transmitted, transcribed, copied, stored in
a data retrieval system or translated in any form or by any means without the express written permission of
IGEL Technology GmbH.
Copyright © 2018 IGEL Technology GmbH. All rights reserved.
Disclaimer
The specifications and information contained in this manual are intended for information use only, are
subject to change at any time without notice and should not be construed as constituting a commitment or
obligation on the part of IGEL Technology GmbH. IGEL Technology GmbH assumes no responsibility or liability
for any errors or inaccuracies that may appear in this manual, including any pertaining to the products and
software described in it. IGEL Technology GmbH makes no representations or warranties with respect to the
contents thereof and specifically disclaims any implied warranties of merchantability or fitness for any
particular purpose.
Warranty
After purchase, just register with us online, and all your IGEL thin clients UD2, UD3, UD6 and UD7 will be
upgraded from a standard 2-year to a 5-year hardware warranty, according to our end customer hardware
warranty declaration, at no additional cost.
The UD Pocket, UD9 will be upgraded to a 3-year hardware warranty. The warranty upgrade does not cover
any additional hardware options.
IGEL is a registered trademark of IGEL Technology GmbH. All hardlware and software names are registered
trademarks of the respective manufacturers. Errors and omissions excepted. Subject to change without
notice.
IGEL Technology GmbH
Hanna-Kunath-Str. 31
28199 Bremen, Germany
Tel.: +49 421 52094 0
Fax: +49 421 52094 1499
info@igel.com
Hardware Reference
IGEL UD3 / IZ3 (IGEL-M340C)
Document Version 1.2 – February, 2019
To Next Page
Loading...
Need help?
General
