Igema FARB2 - Page 4

To Next Page
To Previous Page

Table of contents 
 Configuration via menu .................................................................................... 20 
1 Basics ............................................................................................................. 20 
2 Diagram .......................................................................................................... 20 
3 Description ...................................................................................................... 21 
3.1  Note ............................................................................................................ 21 
3.2  Function of the menu items ......................................................................... 21 
4 Programming .................................................................................................. 22 
4.1  Password input ........................................................................................... 22 
4.2  Input of functionality of the change-over-contact: limiter or controller ......... 22 
4.3  Input of the operating temperature .............................................................. 22 
4.4  Input of the conductivity of the fluid of the plant .......................................... 22 
4.5  Perform calibration ...................................................................................... 23 
4.6  Input of the lower conductivity limit ............................................................. 23 
4.7  Input of the upper conductivity limit ............................................................. 23 
4.8  Test of the relay functionality ...................................................................... 23 
4.9  Programming the conductivity value for 4mA current output....................... 23 
4.10 Programming the conductivity value for 20mA current output..................... 24 
4.11 Programming the attenuation to avoid signal jumps ................................... 24 
 Initial operation ................................................................................................. 25 
 System calibration ............................................................................................ 25 
Switching value settings .................................................................................. 26 
   
Main Page
Igema FARB2 - Page 4

Table of Contents
