iGenix IG2416 - Assembly; Cord Storage; Quick Release Cord Storage

To Next Page

To Previous Page

Assembly

1. Carefully unpack all of the components, making sure to

remove all packaging.

2. Insert the back body into the power head and secure

the back body with the screws.

See fig.1.

3. Insert the removable handle (A) into the body

of the cleaner and press the handle release (L).

See fig.2.

4. Connect the hose and put the dust collector on

to the main body of the unit.

See fig.3.

Cord Storage

1. Make sure that the quick release Cord Holder (K) is in

the upright position.

2. Wrap the Power Cord (R) into place by wrapping in a

clockwise direction around the Power Cord Holders (K).

See fig.4.

Quick Release Cord Storage

3. Rotate the upper Power Cord Holder (K) 180° to u nwrap the power cord.

Note: Wrapping the cord with excessive tension could damage the cord. Ensure that

the vacuum is switched off before plugging into the mains.

Back Body

Fig.1

Fig.4

(K)

(R)

(K)

Fig.2

(L)

(A)

Fig.3